LusterStone®

Available Color Samples (Please make a selection above)

Color Options

Ancient Gray

Antique Parchment

Azure Blue

Black Diamond

Bordeaux

Brown Suede

Cantaloupe

Caramel Sundae

Champagne Mist

Chantilly Lace

Charred Gold

Charred Olive

Cobalt Blue

Coco Plum

Cocoa Chocolate

Copper

Cotton White

Crimson Red

Crushed Pearl

Deep Periwinkle

Ebony Frost

Eggplant

Emerald Ice

Espresso Chocolate

Frosted Denim

Green Onyx

Inkwell Blue

Lady Slipper Pink

« ‹ 1 of 2 › »

*While every effort is made to accurately display color samples, the above image renderings and color swatches are for reference only. Please do not base any color purchases on images or swatches as actual color may vary slightly due to various monitor and graphics card settings.

• Mix thoroughly before each use.
• To obtain the best results, attend a manufacturer approved workshop.
• Under normal conditions, no topcoat is required. A topcoat may be used in areas such as kitchens and bathrooms where extra protection is required.
• When repairing, sand the damaged area first, wipe down and then reapply LusterStone® in thin even coats.
• Always make a sample to ensure the desired result.
• Close the container after each use. Keep air tight. Keep the sides and edges of the container clean. Do not allow dried product to fall into the wet material. A sheet of plastic wrap pressed onto the materials surface will keep it from drying and protect it from foreign matter.
• LusterStone® can be applied to irregular surfaces such as ironwork and assorted fixtures by brush or spray.
• On large walls the application process can be started and stopped at any point in the process without experiencing lap lines.
• LusterStone® works well as a fill coat on textured surfaces.

• Apply 2 coats of SetCoat® or SetCoat® Clear. For best results choose a color that is similar to the LusterStone® hue. Allow this base to dry for a minimum of 24 hours.
• Using a 1/4″ sponge/nap roller apply an even smooth coat of LusterStone®, moving the roller in a random pattern. If necessary, LusterStone® may be thinned up to 20% with water for this step. Allow the LusterStone® to dry for a minimum of 2 hours, then sand lightly with 220 grit sandpaper.
• For the second coat, apply LusterStone® to a flexible plastic or metal trowel. Using smooth sweeping strokes 12″ to 24″ in length spread a thin even coat of the LusterStone® to the work surface.
• Keep the LusterStone® coat thin and smooth. LusterStone® may be thinned up to 10% with water for this step. Once the material has dried for at least 2 hours, lightly sand and then reapply the LusterStone® to any missed spots or areas of low coverage.
• If a higher shine is desired, fine sanding and repeated thin wet coats of LusterStone® can be applied. Sand with 220 grit or finer sand paper and thin the LusterStone® with up to 30% water for this procedure. Trowel the material on to the work surface, and then go back over it, pressing the LusterStone® into the surface while scraping it off at the same time. This method will produce a very tight finish that does not require any further polishing.

• V.O.C. Compliant
• Low Odor
• Smoke Development: 15
• Flame Spread and Smoke Development Indices: Class A
• Sheen: Low Luster
• Environmentally friendly
• Do not apply in temperatures below 55°F, or in damp, cold or humid conditions.
• Some product attributes will vary depending on application method. LusterStone® square footage, finish texture, and sheen can are all dependent on application methods and techniques.
• Technical product- training through Faux Masters Studio workshop recommended

Click Here to Download