WallSilk™

• Watch Faux Masters Studio’s YouTube WallSilk Tutorials
• Mix thoroughly by hand before each use. Mixing with drill at high speeds will result in materiel to be too thin.
• Always make a sample to ensure the desired result.
• To replicate the raw silk look, use recommended base coat SetCoat White
• May be thinned up to 10% with water to achieve more subtle/softer look.
• Close the container after each use. Keep air tight. Keep the sides and edges of the container clean. Do not allow dried product to fall into the wet material. A sheet of plastic wrap pressed onto the materials surface will keep it from drying and protect it from foreign matter.
• On large walls the application process can be started and stopped at any point in the process without experiencing lap lines.

• Apply coat of SetCoat® or SetCoat® Clear on surface to be used as base coat.  Allow this base to dry for a minimum of 24 hours.
• Using a nap roller apply a heavy, even smooth coat of WallSilk™.
• While wet, Drag WallSilk Tool™ vertically or horizontally through the WallSilk™. Allow to dry for 24 hours.
• Roll on a generous coat of ShimmerCoat™ to add shimmer and to protect.

• V.O.C. Compliant
• Low Odor
• Sheen: Low Luster without ShimmerCoat™ to add shimmer and to protect.
• Environmentally friendly
• Do not apply in temperatures below 55°F, or in damp, cold or humid conditions.
• Some product attributes will vary depending on application method. Square footage, finish texture, and sheen can are all dependent on application methods and techniques.

Click Here to Download